Indoor P2 High Refresh Rate LED Display Module - 3840Hz
- Availability: In Stock
Short Description:
Main Specification
Pixel Pitch: 2 mm
Module Size: 320*160 mm
Resolution: 160*80 dots
LED: SMD1515
Brightness: ≥450 nits
Max Current: ≤5 A
Pixel Density: 250000 dots/㎡
Refresh Rate: ≥3840 Hz
Port: HUB75E
Remarks & Key Precautions
1.For indoor Q2 Pro, pixel is relative small, we suggest to go with 640*480mm MG cabinet, cabinet model is QM-Pro-2.
2.Indoor Q2 Pro uses HUB75E, and there is only input port, not output port.
3.Temperature requirement:
- 1) Operating temperature range: -20℃-40℃ other temperature range, need to install temperature control equipment.
- 2) Lamp surface temperature(working period): ≤60℃, temperature control equipment is required to be installed when temperature exceeding the standard.
4.Humidity requirement:
- Storage humidity range: 10% RH-60% RH, humidity over 60% RH requires dehumidification treatment.
5.Keep away from water: Indoor products have low level of protection, water can make the module short circuit, and leads to circuit device damage, so it is necessary to keep away from the water source.
6.Indoor products have no protection level or IP30, and the display should not be exposed to heavy dusty environments, such as decoration and renovation. Special protection is required to protect the display. Installing LED display screen during decoration is strictly prohibited.
7.each group of 220V power line (2.5mm2 copper wire) into the line is only allowed to carry a maximum of 3 boxes, and each group of network connection line into the line according to the actual configuration of the system card parameters.
8.Operating before performing maintenance on the display, you need to turn off the main power of the display